How To Install Whole House Water Filter

How To Install Whole House Water Filter. Open the valves on your faucets and spigots to drain any water remaining in the lines and to relieve the pressure inside the pipes too. Also, ensure you have room under the unit to change the filter when needed.

How to Install a WholeHouse Water Filter howtos DIY from www.diynetwork.com

Make sure you measure the dimensions of the filter carefully and cut the pipes accordingly. Installing a water filtration system will remove contami. If the water supply is switched off, open a tap to release any remaining water in the line and the pipe pressure.

Installing A Water Filtration System Will Remove Contami.

Whole house water filtration system of removing sediment ( dust, leaves, small stone particles ) impurities water.manual filtration system. Also, ensure you have room under the unit to change the filter when needed. Cut the pipe and set up a shutoff valve.

(See Below For A Shopping List And Tools.).

Turn off the main plumbing supply to the house and drain as much water as possible from the pipes by opening all faucets and fixtures and then opening a drawoff valve near the main. To connect to the line, you will have to cut into the pipe in order to make room for the system. Look for a desirable position where the filter can be fixed securely.

You Need An Adapter On Every Side Of The Water Filter To Link The Pipe Size And The New Filter System.

Turn on your water supply completely and allow water to flow out of several faucets to. For the most convenient combination, install a valve on each side. Prepare to clean up a big mess if you don’t.

Having All The Proper Tools.

Determine the location of the prefilter. List of all the materials & tools i bought: Open the valves on your faucets and spigots to drain any water remaining in the lines and to relieve the pressure inside the pipes too.

Sand The Sharp Edges Of The Pipes And Remove Any Built Up Sediment Or Scale From Within The Pipes.

Make sure you measure the dimensions of the filter carefully and cut the pipes accordingly. If necessary, attach a piece of plywood for attaching the filter bracket. Select a location for the filter.